Abstract
In this paper, we report the design and simulation of a wire scanner for the linac of the CSNS (China Spallation Neutron Source). The wire scanner is used to measure the transverse beam profile and the emittance. The effect of beam energy change upon the mechanical design of the wire scanner must be considered. The simulation results of heat on the two specified wires, tungsten and carbon, by using the finite element method software, ANSYS, are presented. In addition, the effect of wire deformation on the beam profile measurement is qualitatively analyzed, and the signal level of the wire scanner is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
