Design and motion planning of a 7-DOF assembly robot with heavy load in spacecraft module

Abstract

Currently, there is great demand for automated assembly of equipment inside spacecraft module, which would require an assembly robot with small size, large workspace, high load capacity, and high flexibility. To meet this demand, a redundant seven-degree-of-freedom (7-DOF) assembly robot with three prismatic joints and four rotating joints is proposed in this study. First, a kinematic model of the assembly robot is established, and the positional forward kinematics are derived. Then, the positional inverse kinematic equations are derived by using the fixed joint method and the coordinate inverse transformation method for the characteristics of the robot with redundant degrees of freedom. The inverse solution optimization model of the assembly robot is designed based on genetic algorithm, and B-spline interpolation algorithm is used for joint trajectory planning. Next, NSGA-2 algorithm is used to construct the trajectory optimization model, and the time-pulsation multi-objective Pareto optimal frontier is obtained. Finally, the joint simulation model of mechatronics and the prototype experiment are established to verify the effectiveness of the optimization results. Analysis shows that the proposed assembly robot has better load-bearing capacity and dynamic characteristics than similar existing assembly robots. Furthermore, the segmented trajectory optimization strategy for the assembly robot using inverse solution optimization, interpolation algorithm, and NSGA-2 based multi-objective optimization gets each motion joint to realize the trajectory tracking function quickly and stably, and the trajectory tracking error is small enough to meet the requirements of end positioning accuracy.