Year-end Sale % OFF 
Abstract
The directional coupler is applied to isolating RX from TX because of low cost and simplicity compared to the circulator in the radio-frequency identification (RFID) reader. Because of unequal phase velocity between odd and even mode, the drawback of the traditional microstrip directional coupler is poor isolation. In this paper, to obtain a good isolation between RX and TX, a novel directional coupler is proposed to be applied to the UHF RFID system with a single antenna. Measurement result shows that the proposed directional coupler possesses a good isolation of -35dB in operating frequency band.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
