Abstract
In radio-frequency identification (RFID) system, a directional coupler has been used to isolate RX from TX due to its simplicity and low cost compared with a circulator. Nevertheless, a conventional microstrip directional coupler has inherent drawback of poor isolation due to unequal phase velocity between even and odd mode. In this paper, a newly proposed circulator using a microstrip directional coupler is proposed to achieve good isolation between TX and RX. The proposed circulator is used for UHF band RFID reader with a single antenna, of which the operating frequency band is 860 MHz ? 960 MHz. The measurement of the fabricated circulator using a modified directional coupler exhibits excellent isolation of 64 dB and directivity of 49 dB in its frequency band. The validity of the proposed circulator is demonstrated by comparing the TX leakage at the RX port of RFID reader system with that of a conventional directional coupler.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
