Design and Implementation of 6-Tap FIR Filter Using MAC for Low Power Applications

Abstract

Abstract: A Significant number of mathematical operations, such as multiplication and accumulation, are often required by a digital signal processing (DSP) algorithm. Many DSP applications have latency limitations, which mean that the DSP operation must be performed within a certain amount of time for the system to function, and because DSP gives high accuracy, filters constructed in DSP have tighter control over the output accuracy. As a result, DSP applications must be fast, have a high throughput, and use little power. Filters with a finite impulse response (FIR) are commonly employed in digital signal processing (DSP) applications. A FIR filter that is efficient in terms of electricity is being built. The multiplier and accumulator (MAC) unit used a new implementation approach to develop this system. FIR filter is a type of filter. Multipliers, adders, and a variety of other components are commonly used in FIR filters. Multipliers, adders, and a series of delays are used to form the filter's output in FIR filters. The goal of this project is to design and implement a 6-tap finite impulse response (FIR) filter by replacing multipliers with an 8-bit Multiplier and Accumulator (MAC) unit within the FIR filter, where a low-power MAC unit is always a key to achieving high performance in a DSP system, and D flip-flops are used in place of delays and constructed using a latch-based design. The Wallace tree Multiplier was utilised in the construction of the MAC unit because it reduces the amount of partial products, and the adders used for accumulation are half adders and full adders. In the FIR filter, for the purpose of summing This work evaluates performance of FIR filter in terms of speed and power and synthesis are executed in Xilinx Vivado 2018.1 software environment and the implementation is done using VHDL codes. The result analysis shows that the proposed FIR filter consumes low power than conventional (standard) FIR filter. As the dynamic power results up to 11.932W and after implementation it results up to 12.029W. Keywords: MAC, Low power, latch-based design.