Abstract
Abstract: In this study, structural analysis is investigated on conventional piston made of cast iron. Secondly analysis are performed on piston made of aluminum, titanium alloy , structural steel and fiber glass. The material used for the design of piston should have light weight, low cost, structurally and thermally withstand at very high pressure and temperature condition that will occur in combustion process. In this project, It has been decide to study a particular piston design And its capability for maximum gas pressure. In this work, initial planning is to make piston model using solid modeling software CATIA V5. It has been decided to mesh the geometry analyze using ANSYS. For the analysis of piston input conditions and process of analysis, a lot of literature survey has been done. High combustion gas pressure will act as a mechanical loads and causes major stresses in the critical region of the piston. Detailed static structural analysis is carried out for various loading conditions like maximum gas pressure load.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal for Research in Applied Science and Engineering Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
