Abstract
This paper presents time interleaving as an approach to improve the performance of programmable receiver front ends based on filtering-by-aliasing. Using two parallel periodically time-varying paths, a sharp programmable filtering response is produced at RF, while achieving a good wideband S <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">11</sub> . The implemented receiver achieved a filter stopband suppression of 70 dB with a transition band of only 4× RF bandwidth, while S <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">11</sub> is better than -10 dB throughout most of the receiver local oscillator range. Analysis for achieved S <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">11</sub> and noise figure are shown, while detailing methods to improve filtering performance in the presence of important circuit parasitics. The effects of mismatches between time-interleaved paths are also analyzed and quantified.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.