Density of pure and mixed NaCl and CaCl2 aqueous solutions at 293 K to 353 K and 0.1 MPa: an integrated comparison of analytical and numerical data

Abstract

This study reports on newly acquired density data of synthetically prepared pure and mixed NaCl and CaCl2 aqueous solutions that span a wide range of geothermally encountered concentrations and mixing ratios. The analytical data are provided for the temperature range of 293–353 K at ambient pressure. For the reproduction of that data, PHREESCALE was used. The predictive potential of this numerical tool regarding the density of geothermal fluids of known composition was the major target herein. As a result, the measured data are in good agreement with previous analytical studies found in the literature. Possible sources of errors are discussed in this paper. Density data of the mixed solutions at temperatures other than ambient are unique and close existing data gaps. The numerical model reproduces the newly measured and already existing density data within an error band of approximately 1%. For further use in geothermal applications, this can be considered an excellent agreement. Moreover, the model yields a direct calculation of density without the need to establish complex empirical equations of state and mixing rules. Finally, sensitivity calculations performed with a thermal–hydraulic (TH) numerical reservoir model demonstrate the required accuracy of fluid density for reliably predicting the long-term performance of deep geothermal energy systems. In terms of the productivity index and the timing of thermal breakthrough it shows that the present analytical and numerical uncertainty in density is small enough to reliably state both reservoir parameters.