Abstract
The setting up of a practical electrically driven light commercial demonstration vehicle with integrated photovoltaics (PV) is reported. The demonstrator vehicle is equipped with 15 modules based on the crystalline Si/amorphous Si heterojunction technology. The nominal total peak power under standard testing conditions is 2180 Wp. Specifically, the PV‐converted energy is fed into the high‐voltage (HV; 400 V) board‐net for a utilization of the large capacity of the HV battery and thus for direct range extension. The demonstrator vehicle is equipped with irradiation, wind, temperature, magnetic, and global positioning system sensors. Irradiation and temperature as well as the energy flows from modules, maximum power point trackers (MPPTs), low‐voltage buffer battery to HV battery via DC/DC, and from the HV battery to the loads during an exemplarily test drive day (May 31, 2021) are monitored. The range extension obtained at this day on our test route (51° 59′ N, 9° 31′ E) was 36 km, the corresponding CO2 savings account for ≈2.3 kg. The chain efficiency of the electronic components from the input side of the MPPTs to the HV output side of the DC/DC was 68.6%, whereas the DC/DC itself has an average efficiency of 90%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.