Demarcation of groundwater quality domains using GIS for best agricultural practices in the drought-prone Shanmuganadhi River basin of South India.

Abstract

A study was conducted to evaluate the suitability of groundwater in the drought-prone Shanmuganadhi River basin of south India for best agricultural practices since the surface water that exists in this basin is not sufficient to meet out the demand. As the quality of groundwater is not uniform in the hard rock aquifers of this basin, the work was carried out to demarcate the suitable groundwater quality zones for the agricultural activities. Sixty-one groundwater samples were collected and analyzed for various parameters such as electrical conductivity (EC), pH, TDS, major cations (Ca2+, Mg2+, Na+, and K+) and anions (Cl-, SO42-, HCO3-, PO43-, NO3-, and F-). To demarcate the feasible zones for agricultural practices, irrigation water quality parameters like EC, sodium adsorption ratio (SAR), percent sodium (Na %), residual sodium carbonate (RSC), magnesium hazard ratio (MHR), Kelly's ratio (KR), and permeability index (PI) were computed. Furthermore, the irrigation water quality representation diagrams like USSL, Wilcox, and Doneen were prepared, and their outputs were spatially plotted using the Geographical Information System (GIS) to identify the suitability domains of groundwater for irrigational practices. Interpretation of irrigation water quality parameters and diagrams indicate that 2% of groundwater samples represented "low" salinity, 26% of samples represented "medium" salinity, 66% of samples represented "high" salinity, and 6% of samples represented "very high" salinity. Similarly, about 59% of samples represented the low alkaline/sodium category and 41% of them represented the medium alkaline category. The USSL output shows that about 2% of samples of the basin signified "low salinity with low alkalinity" category (C1S1), 28% of samples signified the "medium salinity with low alkalinity" category (C2S1), 33% of samples signified "high salinity with low alkalinity" category (C3S1), 28% of samples signified the "high salinity with medium alkalinity" category (C3S2), and 10% of samples signified the "very high salinity with medium alkalinity" category (C4S2). Groundwater is suitable for irrigation in 277.52km2 area of the basin. It is moderately suitable in an area of 318.46km2 and poorly suitable over 38.64km2. This study recommends that groundwater with moderate suitability could only be used for irrigating permeable soils and for cultivating salt-tolerant crops. The addition of gypsum to soil might be helpful to increase the infiltration capacity and osmotic activity. However, poorly suitable area should be avoided for agricultural practices.