Degradation of sodium dodecylbenzene sulfonate (SDBS) and high efficiency treatment of real grey water by TiO2-loaded stainless steel mesh under VUV irradiation

Abstract

Reusing treated greywater indoors in buildings is an advanced strategy to increase the utilization of limited water resources, but currently there is a lack of feasible technologies for efficiently purifying greywater indoors. In this study, we construct the heterogeneous TiO2-stainless steel mesh (SSM) interface with photocatalytic degradation of sodium dodecylbenzene sulfonate (SDBS) by under vacuum ultraviolet (VUV) irradiation. At the initial SDBS of 10 mg/L, the degradation rates of SDBS with UV/TiO2-SSM and VUV/TiO2-SSM process were 53 % and 74 % respectively within 50 min. The results of specific scavengers experiments and EPR analysis revealed that the ·OH, h+ and direct photolysis contributed to SDBS degradation and mineralization. The degradation rate of SDBS in VUV/TiO2-SSM process was higher at weak acid or weak alkali conditions, while the performance of UV/TiO2-SSM process was better at alkaline conditions. Both Cl− and HCO3− could inhibit SDBS degradation, while SO42− slightly promoted the degradation. Active oxygen species mainly degrade SDBS in two ways: by attacking the α carbon, β carbon, or branched chain carbon on the alkane chain; or by attacking the adjacent carbon on the alkane chain, resulting in the formation of three branch forms of products. The toxicity of the intermediate products shows a decreasing or stable trend. The experiment shows that UV or VUV photocatalytic TiO2-SSM has a good prospect of removing anionic surfactant in the real greywater. This study provides strategies for the development and design of indoor water reuse technologies and devices in buildings.