Deformation Assessment of the Manually Pre-Bent Titanium Miniplates in Orthognathic Surgery With Finite Element Analysis.

Abstract

This study summarized the literature regarding the application of pre-bent titanium miniplates in orthognathic surgery and evaluated the extra deformation of the manually pre-bent titanium miniplates via finite element analysis for acquiring higher surgical accuracy. The literature was reviewed with a chart. Three models of titanium miniplates with different thicknesses (1.0 mm, 0.8 mm, 0.6 mm) were created using COMSOL Multiphysics software for biomechanical behavior analysis. The 3 models were virtually bent into 5 angles (15 degree, 30 degree, 45 degree, 60 degree, 80 degree). respectively to simulate the preoperative virtual bending, then to simulate the practical manual bending via finite element analysis. The stresses and displacements of these models were recorded. The models from virtual bending simulation and manual bending simulation were registered to analyze the deviations. The results showed that the maximum stress and the displacement deviations between the virtual bending models and the manual bending models increased with the thickness and bending angle of the pre-bent miniplate models. To improve the surgical accuracy, measures should be applied to the manually pre-bent titanium miniplates to reduce the extra deformation when the plate being thicker and the bending angle being larger.