Defect formation, microstructure evolution, and mechanical properties of bobbin tool friction–stir welded 2219-T8 alloy

Abstract

Bobbin tool friction stir welding (BT–FSW) is a novel and effective welding method for aluminum alloys, but microvoid defects are usually formed in the nugget zones (NZ). Therefore, it is important to understand the formation mechanism of microvoid defects and their effect on the fracture behavior of joints. In the present study, 6 mm thick 2219–T8 aluminum alloy plates were subjected to BT–FSW under a constant rotation rate of 300 rpm and welding speeds of 150–500 mm min–1 with the objective of analyzing the evolution of microvoid defects and their effect. The results showed that, lower welding speeds resulted in microvoid defects in the band pattern structure on the retreating side (RS) of the NZ, and the size of the defects decreased with increasing the welding speed, while sound joints were obtained under higher welding speeds. In contrast to conventional FSW precipitation–hardened aluminum alloys with the lowest hardness zone (LHZ) at the heat affected zone (HAZ), the LHZs of the BT–FSW 2219–T8 joints were located at the thermal–mechanically affected zone (TMAZ). Digital image correlation (DIC) of large tensile samples showed that the microvoid defects exhibited an obvious effect on the tensile deformation and fracture behavior of the joints due to the decrease in the maximum strain and lack of necking. Mini-samples in different layers further confirmed that cracks initiated from the microvoid defects in the NZ. However, the sound BT–FSW 2219–T8 joints fractured along the LHZs on the RS, with a maximum joint strength coefficient of 78.1% being achieved.