Decoupling the anodic and cathodic behavior in asymmetric electrochemical hydroiodic acid decomposition cell for hydrogen production in the iodine-sulfur thermochemical cycle.

Abstract

Listen

Translate article

The HI section of the iodine-sulfur (I-S) thermochemical cycle for hydrogen production is one of the most energy-intensive sections and with significant material handling challenges, primarily due to the azeotrope formation and the corrosive nature of the hydroiodic acid-iodine-water mixture (HIx). As an alternative, the single-step direct electrochemical decomposition of the hydroiodic acid (HI) to generate hydrogen can circumvent the challenges associated with the conventional multistep HI section in the I-S cycle. In this work, we present new insights into the electrochemical HI decomposition process by deconvoluting the contributions from the anodic and the cathodic sections in the electrochemical cell system, specifically, the redox reactions involved and the overpotential contribution of the individual sections (anolyte and catholyte) in the overall performance. The studies on the redox reactions indicate that the HIx solution output from the Bunsen reaction section should be used as the anolyte. In contrast, aqueous HI without any iodine (I2) should be used as the catholyte. In the anodic section, the oxidation proceeds with I2 as the final oxidized species at low bias potentials. Higher positive potentials result in iodate formation along with oxygen evolution. For the catholyte section, I2 and tri-iodide ion reduction precede the hydrogen evolution reaction when I2 is present along with HI. Furthermore, the potential required for hydrogen production becomes more negative with an increasing I2/HI ratio in the catholyte. Polarization studies were conducted with simultaneous deconvolution of the anodic and cathodic behavior in a two-compartment cell. Model fitting of the polarization data revealed that the anolyte section's activation overpotential is negligibly low. In contrast, the activation overpotential requirement of the catholyte section is higher and dictates the onset of hydrogen production in the cell. Furthermore, the catholyte section dominates the total overpotential losses in the cell system. Operation in the ohmic resistance-dominated zone resulted in close to 90% current efficiency for the electrochemical HI decomposition. The results highlight that the potential for process improvement lies in reducing the ohmic resistance of the anolyte section and in lowering the activation overpotential of hydrogen evolution in the catholyte section.