Abstract
This paper presents a single stage DC-DC Buck power converter for an electric bike system which is used as a DC motor driver. The DC motor is firstly parameterized to identify and estimate the dynamic of electrical and mechanical parameters. In this paper, the simulation and the experimental validation of the system are presented. A model of a DC-DC Buck converter fed with DC motor is developed. The simulation was carried out using Matlab-Simulink software and the experimental setup is based on a built prototype of Atmega 328 microcontroller board. The similarities of voltage and current input/output waveforms between simulation and experimental results proved that the single stage DC-DC Buck converter with parameterized DC motor suitable to prototype a low power electric bike model.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call