Abstract
AbstractPure perovskite Pb0.92La0.08(Zr0.68Ti0.32)0.98O3 (PLZT (8/68/32)) crystal powders with good dispersibility are prepared by using gel‐hydrothermal method. The effects of mineralizer concentration, hydrothermal treatment time, and excess lead content on powder crystallization and morphology are examined and analyzed. The suitable mineralizer concentration and hydrothermal treatment time are found to be helpful to promote the PLZT crystal powders growth and improve the particle surface morphology. Noticeably, the introduction of excessive Pb can well compensate for the lack of A‐site ions in the solution, thereby promoting the formation of rhombohedral PLZT crystal powders. The following optimized hydrothermal conditions are established: the temperature ≈230 °C, the mineralizer concentration ≈2 m, the hydrothermal treatment time ≈24 h, and the amount of excess Pb ≈ 80%. The obtained PLZT crystal powders with clean and complete cube morphology, uniform particle size, and excellent dispersibility would be used as the crystal seeds applying in the seed‐induced growth of PLZT ceramics.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.