Cross-section behaviour and capacity of cold-formed austenitic stainless steel flat-oval hollow sections under combined compression and bending

Abstract

Flat-oval hollow section is composed of two semi-circular elements and two flat elements, with the semi-circular elements (exposed to wave and wind) offering a low level of hydrodynamic and aerodynamic drag and the flat elements facilitating connections with other members perpendicular to the wave and wind directions. This paper presents an experimental and numerical study of the cross-section behaviour and resistance of cold-formed austenitic stainless steel flat-oval hollow section stub columns under combined compression and bending. An experimental programme, including initial local geometric imperfection measurements and ten major-axis and minor-axis eccentric compression tests, was firstly carried out, with the test setups, procedures and results fully reported. Following the experimental programme, a numerical modelling programme was performed, with finite element models developed and validated against the eccentric compression test results and then used to conduct parametric studies to generate additional numerical data. Based on the test and numerical results, the relevant codified design interaction curves for cold-formed austenitic stainless steel rectangular hollow sections were evaluated for the applicability to their flat-oval hollow section counterparts. It was found from the evaluation results that the codified design interaction curves led to inaccurate resistance predictions, mainly due to the conservative end points (i.e. cross-section resistances under pure compression and pure bending) and inefficient shapes. Finally, a new design interaction curve was proposed through the use of more accurate end points and more efficient shape and offered more accurate and consistent resistance predictions for cold-formed austenitic stainless steel flat-oval hollow sections under combined loading than the codified design interaction curves.