Corrosion assessment of nitric acid grade austenitic stainless steels

Abstract

The corrosion resistance of three indigenous nitric acid grade (NAG) type 304L stainless steel (SS), designated as 304L1, 304L2 and 304L3 and two commercial NAG SS designated as Uranus-16 similar to 304L composition and Uranus-65 similar to type 310L SS were carried out in nitric acid media. Electrochemical measurements and surface film analysis were performed to evaluate the corrosion resistance and passive film property in 6 N and 11.5 N HNO 3 media. The results in 6 N HNO 3 show that the indigenous NAG 304L SS and Uranus-65 alloy exhibited similar and higher corrosion resistance with lower passive current density compared to Uranus-16 alloy. In higher concentration of 11.5 N HNO 3, transpassive potential of all the NAG SS shows a similar range, except for Uranus-16 alloy. Optical micrographs of all the NAG SS revealed changes in microstructure after polarization in 6 N and 11.5 N HNO 3 with corrosion attacks at the grain boundaries. Frequency response of the AC impedance of all the NAG SS showed a single semicircle arc. Higher polarization resistance ( R P) and lower capacitance value (CPE-T) revealing higher film stability for indigenous NAG type 304L SS and Uranus-65 alloy. Uranus-16 alloy exhibited the lowest R P value in both the nitric acid concentration. Auger electron spectroscopy (AES) study in 6 N and 11.5 N HNO 3 revealed that the passive films were mainly composed of Cr 2O 3 and Fe 2O 3 for all the alloys. The corrosion resistance of different NAG SS to HNO 3 corrosion and its relation to compositional variations of the NAG alloys are discussed in this paper.