Abstract
Despite the good corrosion resistance of chromate coatings, there is a general agreement in eliminating the Cr(VI) compounds for corrosion protection owing to their health hazards. Coil coaters are looking for maintained or improved anticorrosion properties. Therefore, coil coated materials painted with conventional polyester topcoat and with either standard strontium chromate or water based epoxy Cr(III) primer were evaluated through a battery of accelerated and outdoor exposure tests. Physicochemical properties, corrosion potential and electrochemical impedance were measured before and after exposure of coated panels in salt spray, humidity or weathering chambers. Experimental results showed that the conventional chromatised polyester primer/polyester topcoat system provides better protective properties than the water base epoxy primer with Cr(III)/polyester system. This was also observed in replicated panels exposed outdoor but just after two years. The protection mechanism was analysed on the basis of the experimental results and the applied formulation type.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
