Abstract
The functioning and performance of today’s integrated circuits and sensors are highly affected by the thermal properties of microscale silicon structures. Due to the well known size effect, the thermal properties of microscale silicon structures are not the same as those of the bulk silicon. Furthermore, stress/strain inside microscale silicon structures can significantly affect their thermal properties. This article presents the first thermal conductivity measurements of a microscale silicon structure under applied compressive stress at 350 K. Atomic force microscope (AFM) cantilevers made of doped single-crystal silicon were used as samples. A resistance temperature detector (RTD) heater attached to another RTD sensor was used as the heating module, which was mounted onto a nanoindentation test platform. This integrated system applied compressive load to the cantilever in the longitudinal direction while supplying heat. The thermal conductivity of the cantilevers was calculated using steady state heat conduction equation. The result shows that the measured thermal conductivity varies from 110 W/(m·K) to 140 W/(m·K) as compressive strain varies from 0.1% to 0.3%. Thermal conductivity is shown to increase with increase in compressive strain. These results match with the published simulation values. The measured thermal conductivity and stress values vary in the similar manner as a function of applied strain.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.