An Investigation of Tensile, Fatigue, and Fracture Behavior of 3D-Printed Polymers

Abstract

Abstract The progression of manufacturing technology has significantly benefited from the adoption of 3D printing techniques, which enable the production of parts with intricate geometries. However, it is important to acknowledge that components fabricated through this additive manufacturing method frequently manifest defects and exhibit a propensity for failure under severe conditions. Therefore, a thorough examination of the mechanical properties of these parts is essential to effectively reduce the failure. This study aimed to explore the mechanical properties of two prevalently used 3D-printed polymers, specifically Onyx and ABS, by integrating computational and experimental analyses. The experimental study utilized a material testing system and digital image correlation (DIC) technology, while the computational analysis covered the finite element (FE) modeling of the 3D-printed samples. The research focused on evaluating the tensile strength and fatigue resistance of the specimens printed in various orientations, alongside a detailed investigation of their fracture behavior. The crack propagation analysis was carried out using the DIC system and the Separating Morphing and Adaptive Re-meshing Technology (SMART) scheme in ANSYS. It was observed that upright build orientation produced the weakest samples for axial loading and specimens with notches failed earlier than those without. Moreover, Onyx was found to have a higher resistance to fracture or failure compared to ABS. The FE modeling results demonstrated strong agreement with the experimental results, validating their accuracy and reliability in characterizing the critical mechanical response of 3D-printed parts rapidly and cost-effectively.