Correcting land surface temperature from thermal imager by considering heterogeneous emissivity

Abstract

It is fundamental to obtain accurate land surface temperature (LST) to study surface energy process. Infrared thermal imagers are commonly used for deriving LST on the basis of radiance measurements. However, when deriving LST from brightness temperature of a blackbody in thermal imagers, thermal imagers only allow setting a fixed land surface emissivity (LSE). This causes uncertainty in retrieving thermal infrared (TIR) temperature from heterogeneous surfaces with varied LSE, such as those covered in vegetation. Corrections can be made using the Normalized Vegetation Index (NDVI). However, commercial thermal imagers provide only red (R), green (G), and blue (B) bands without a near infrared band so NDVI cannot be calculated on the same instrument and is commonly not available. We propose an alternative method to estimate LSE using RGB-based vegetation index. Thereafter the estimated LSE was used to correct the TIR temperature derived from the fixed LSE. An experiment was conducted to validate the proposed correcting method. The results show that 1) the corrected LST values were closer to the ground truth, with a mean absolute error (MAE) of 0.41 ± 0.34 °C, whereas the MAE was 0.75 ± 0.56 °C for the uncorrected LST; 2) the more heterogeneous the surface, the greater the difference between the corrected and uncorrected LST values, indicating the necessity of LST correction when applying thermal imagers over heterogeneous surface.