Abstract
Next-generation stretchable electronics, such as wearable electronics and implantable sensors, require stretchable conductive fibers. Despite their great popularity for wearable electronics, conducting polymers do not sustain deformation very well because of their rigid conjugated backbone. Here, we report the production of stretchable conductive poly(3,4-ethylenedioxythiophene)/poly(styrene sulfonate) (PEDOT/PSS)- conjugated polymer fibers, using optimal wet-spinning, followed by hot drawing. We engineer the fibers by introducing a copolymer, polyethylene-block-poly (ethylene glycol) (PBP), that modifies both the electrical and mechanical properties of the raw PEDOT/PSS. We then systematically investigate the effects of the PBP fraction (fs) on the properties of the PEDOT/PSS by analyzing the changes in the conductivity, morphology, stretchability, and conformation of the PEDOT chains. We find that the conductivity of PEDOT/PSS increases from 311 ± 8 S/cm to 415 ± 12 S/cm (133% increase), when fs = 0.4, and that the strain of the fibers, at failure, is as high as (ε = 36%) for fs = 0.7, eq. 3x the value of as-spun PEDOT/PSS fibers. Raman and XRD analyses show that the conformational changes from benzoid to quinoid structures, in the PEDOT chains, significantly enhance the conductivity of the fibers. This conformational change facilitate the switch from a coil structure of PEDOT/PSS into a linear or an extended-coil conformation that increases interchain interaction.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.