Controlled processing of polymer nanoribbons: Enabling microhelix transformations

Abstract

ABSTRACTFlow‐coated, two‐dimensional polymer ribbon structures undergo a shape‐transformation into a three‐dimensional helix upon their release into a solution. Driven by surface forces and due to geometric asymmetry, the helix radius and spring constant depend upon the ribbon cross‐section dimensions, surface energy, and material elastic modulus. Such spring‐like microhelices offer multiple functionalities combined with mechanical stretching and shape recovery. Fabricating such microhelices requires a sequence of processing steps, beginning with flow‐coating of ribbons on a substrate, followed by etching of a “scum layer” to allow for an independent release into a solution, upon which shape‐transformation occurs. During the deposition‐etch‐release sequence, various control parameters influence the nanoribbon size and geometry, hence the helix properties. The experimental study presented here focuses on the influence of meniscus height, substrate velocity, substrate surface energy, and etch time on nanoribbon size (height and width), scum layer thickness, and helix radius. The results show that meniscus height and contact angle dictate flux toward the meniscus edge and volume available for spatial assembly, allowing control over the aspect ratio of ribbons. We vary the aspect ratio by two orders of magnitude, while maintaining geometric asymmetry needed for helix shape‐transformation. We provide robust scaling for the nanoribbon size and geometry and report the advantages and disadvantages of different parameters, in the control of polymer nanoribbon and helix fabrication. © 2019 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2019, 57, 1270–1278