Abstract
The highest power conversion efficiency (PCE) of solid-state perovskite solar cells (ssPSCs) has achieved 20.1% recently. There isreason tobelieve that ssPSCs is a strong competitor with silicon and CIGS solar cells in photovoltaic field. The deep understanding of operation mechanism of ssPSCs is essential and required to furtherly improve device performance. The configuration and excition type are similar to inorganic semiconductor solar cells. Therefore, Solar Cell Capacitance Simulator (SCAPS), a device simulator widely using in inorganic solar cells, was employed to controllably design ssPSCs. The validity of device simulation was verified by comparing with real devices from reported literatures. The influence of absorber thickness on device property was discussed, which indicate that it exists an optimal thickness range. Two hypothetical interface layers, TiO2/perovskite layer and perovskite/HTM layer, were introduced into the construction model to consider the effects of interfaces defect density on device performance. It revealed TiO2/perovskite has stronger impact than perovskite/HTM, because higher excess carrier density existing at TiO2/perovskite will cause more recombination rate. In addition, hole transport materials (HTM) parameters, hole mobility and acceptor density, were chosen to study the impact of HTM characteristics on PCE. The analysis illuminate that the design of HTM layer should balance hole mobility and acceptor density. Meanwhile, different HTM candidates were selected and replaced typical HTM layer. The discussion about the function of candidates on solar cells performance demonstrated that a thiophene group hole-transporting polymer (PTAA) and a copper-based conductor (CuI) both have relatively high PCE, which is due to their wide bandgap, high conductivity, and better chemical interaction with perovskite absorber.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.