CONTROL OF WORKING BODY OF AIRBORNE AIRCRAFT POSITIONING MECHANISMS BY MEANS OF STEPPER MOTOR IN STEP CRUSHING MODE

Abstract

Step splitting control mode of the electric drives stepper motors working bodies of the positioning mechanisms of onboard aviation equipment is carried out by means of programmable controllers. From their output signals, pulse-wide signals are formed by means of drivers that control power transistors, which are included in the windings of a stepper motor.
 A simpler version of building control systems for stepper motors (SM) involves the use of programmable timers, which requires its reprogramming when changing the step splitting factor.
 In the process of step splitting the shape of the current in the winding of the SM approaches sinusoidal with an increase in the number of sine discretes stored in the controller's memory. However, in this case, the sine samples must follow at a higher frequency, which difficulties in programming them.
 There is a problem of finding new ways of programming in the controller's memory information about the changing shape of the supply voltage SM in the process of step splitting in order to ensure the maximum speed of the code and the minimum consumption of the processor time of the microcontroller.
 To solve this problem, it is proposed to specify information about the changing shape of the SM supply voltage not in the form of sine samples (table method), but the sum of the coefficients of the Walsh-Fourier series, the amplitudes of which depend of value of the step splitting factor.
 The Walsh-Fourier series is a natural basis for approximating the pulsed supply voltage of a stepper motor. Structural diagrams of digital and analog systems for stepper motors in the step splitting are proposed.
 In the digital control system, the Walsh matrix is entered into the permanent memory of the controller, the size of which is determined by the value of the minimum step splitting factor, and the column vectors of the coefficients of the amplitudes of the Walsh functions are entered into the random-access memory, each of which corresponds to its step splitting factor.
 The input controller sets the program for implementing the inverse Walsh transform to the control controller, as a result of which control signals for the driver are generated at the output of the DAC controller. As its output, control signals are generated for power transistors including in the windings of the stepper motor.
 In the analog control system, the main links are the Walsh functions generator and the block of summing coefficients. In the block of summing coefficients of each Walsh function is assigned an amplitude corresponding to a given step splitting factor, and then they are summed. As a result, a pulsed voltage is formed, which is fed to the input of the driver, as in a digital system. It is shown that an analog control system can be used to form low-frequency quasi- sine signals of high stability. They can be used in precision electric drives with high stability.