Experimental studies of using the digital control system in power conversion equipment of high-voltage power supply systems in spacecrafts with a hydrogen energy accumulator

Abstract

Solar-hydrogen energy for spacecraft, space interplanetary stations, space bases on the planets of the solar system must reliably provide energy: spacecraft during peak periods (repairs at a space facility, energy-consuming experiments, cleaning of facilities, regeneration of waste to extract oxygen and hydrogen, etc. .d.) and bases on planets, especially where the night lasts for a long time.The onboard hydrogen module of the solar-hydrogen plant includes: a container with water; distiller; deionizer; water lines with adjustable shut-off valves; electrolyzer; cryogenic side tanks with hydrogen and oxygen; fuel cell, hydrogen safety sensor systems based on leakage and concentration sensors; level gauges; cryogenic and gas pipelines of hydrogen and oxygen; onboard cryo-refrigerator; automatic control system for the hydrogen module. The article presents the results of experimental studies of static, dynamic and mass-dimensional characteristics of power conversion equipment (hereinafter - PCE) in the power supply system (hereinafter - PSS) of the spacecraft (hereinafter - spacecraft) with a digital control system. The purpose of experimental research is to verify the theoretical results obtained earlier in the design of digital PCE control systems of high-voltage PSS spacecraft, including the study of static and dynamic characteristics. We developed and manufactured an experimental PCE sample with an output power of 2500W in this research. It includes: four voltage stabilization modules and the 100V load supply output bus filter. Each voltage stabilization module includes a battery energy conversion channel, a solar battery energy conversion channel and a digital control system unit. The power conversion channel of the accumulator battery is designed and made on the basis of a bridge volt-booster inverter-transformer circuit. Voltage control in energy converter of accumulator battery is based on phase shift in control pulses of transistors in adjustable inverter rack related to unregulated one. The power conversion channel of the solar battery is designed and made on the basis of a two-phase circuit of a direct voltage converter of an increasing type with switching throttles. The digital control system of the voltage stabilization module is designed on the basis of analogues in the modern electronic component base in the Space class and consists of four identical channels. Each channel of the control system controls its own voltage stabilization module. We obtained the following results during our experimental studies: some pulsations of the output voltage of the energy conversion equipment during operation on an active load, transient processes of the output voltage of the energy conversion equipment during pulsations of the load current without changing the mode of operation, transient processes of the output voltage of the energy conversion equipment when changing the modes of its operation and weight and size characteristics for different values of the output power. The obtained results of experimental studies confirm the previously obtained theoretical results, and also showed that the use of a distributed digital control system will increase the specific energy characteristics of the newly developed PSS spacecraft while ensuring the given static and dynamic characteristics of output voltage quality. The results of the work are designed to create a new on-board power conversion equipment for power supply systems of promising spacecraft. The area of application of the project results is space instrumentation.