Abstract
This paper presents the modeling and control design for a wind energy conversion scheme using induction generators. The scheme consists of a three-phase induction generator driven by a horizontal axis wind turbine and interfaced to the utility through a double overhead transmission line. A static VAr compensator was connected at the induction generator terminals to regulate its voltage. The mechanical power input was controlled using the blade pitch-angle. Both state and output feedback controllers are designed using MATLAB software to regulate the generator output. From the simulation results, the response of closed loop system exhibited a good damping and fast recovery under different type of large disturbances.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call