Abstract
Particles in the head disk interface may cause large contact forces acting on the slider as well as thermal asperities in the read/write signal. This is especially true for the close spacing required for 1Tbit∕in.2. In this paper, a three-body contact model is employed to study the effects of a particle entrapped between a slider and a disk. A criterion for determining a particle’s movement pattern is proposed. The study of particles in the head disk interface shows that large particles are likely to slide between the slider and disk interface, and the particles going through the trailing pad of an air bearing slider cause severe contact forces on the slider and generate large heat sources. The frictional heating study shows that the temperature around the magnetoresistive head increases to about 5°C for a single 200nm particle passing through the trailing pad of the slider. The effects of the particle size, disk material, and friction coefficient are also studied. It is found that the disk and slider materials and the frictional coefficient between the materials largely affect the contact force acting on the slider by an entrapped particle as well as the temperature rise at its contact region. It is also found that the friction coefficient largely affects a particle’s movement pattern in the head disk interface.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have