Abstract
New types of face worm-gear drives are considered. The authors propose methods for localization of bearing contact and reduction of transmission errors achieved by double-crowning of the worm of the drive with respect to the hob, the tool that generates the worm-gear. A computer program for simulation of meshing and contact is provided. Numerical examples based on application of two types of hob thread surface are considered.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: Computer Methods in Applied Mechanics and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.