Abstract
A theoretical analysis of the surface recombination, surface band bending and photoluminescence (PL) under strongly absorbed light illumination was performed for n-type Si and AlGaAs surfaces. A very strong dependence of the so-called effective surface recombination velocity ( S eff), surface photovoltage (SPV) and photoluminescence quantum efficiency ( Y PL) on both the excitation intensity and surface Fermi level position was found from rigorous computer calculations. The initial surface band bending was varied from accumulation to inversion by introducing the surface fixed charge ( Q FC) in the Si case, and from weak to strong depletion by increasing the surface state density ( N SS0), in the AlGaAs case. It was revealed that S eff can be significantly reduced (almost four orders of magnitude on Si surface) by shifting the surface Fermi level towards band edges. On the other hand, a deep quenching of PL efficiency was observed for the values of N SS around midgap above 5×10 10 cm −2 eV −1 on AlGaAs surface. In addition, a comparison of simulated Y PL dependencies versus photo-excitation with the experimental data obtained for MBE-grown AlGaAs layers passivated by ultrathin Si interface control layer was performed. This technique of passivation is known to reduce the interface state density down to the range of 10 10 cm −2 eV −1.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.