Abstract
A method is presented for evaluation of variations in the thickness of articles produced by the combined method of mechanical and pneumatic shaping. The adequacy of the method is assessed by comparing theoretical results with practical data on the distribution of wall thickness in a specific article. Theoretical and practical distributions of the relative wall thickness of an article are indicated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.