Abstract
Additive manufacturing is an effective method to realize complex biomimetic topology and tunable mechanical property. In the current work, to meet the requirements of damping buffers and energy absorbers, triply periodic minimal surface (TPMS) structure using two soft polymeric blends as feedstock materials were gradient design and manufactured via fused filament fabrication. The internal topography of Schwarz P, Gyroid and Diamond TPMS structures were observed by scanning electron microscope and micro-computed topography. The compressive test results demonstrated that Diamond possessed superior load-carrying and energy absorption capacity to Gyroid and Schwarz P structure. The energy absorption for graded Diamond and Gyroid structures were better than the uniform controls, whereas Schwarz P displayed an opposite trend. Meanwhile, less internal damage and good resilient behavior were observed for polymeric blends with better resistance to plastic deformation. Lastly, cycle loadings were conducted, and the elastic energy, consumed energy as well as the specific damping capacity for graded and uniform TPMS soft structures were explored. With the increase of loading cycles, the Diamond TPMS structure exhibited a better damping behavior whereas Schwarz P displayed an elastic behavior. The elastic deformation was gradually replaced by the inelastic deformation of energy consumption and dissipation.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call