Comparison of the machinabilities of Ti6Al4V and TIMETAL ® 54M using uncoated WC–Co tools

Abstract

Single-point turning tests of cylindrical bars were undertaken to analyse and compare the machinability of Ti6Al4V, the most common titanium alloy, and TIMETAL ® 54M, a newly developed alloy with similar mechanical properties as Ti6Al4V but with better machinability. Conventional cooling and uncoated WC–Co tool inserts were used in the study, because they are the most recommended for machining these materials. The feed and the depth of cut were maintained constant, and only the cutting speed was varied because it is the most affecting parameter. Adhesion of workpiece material in the form of a built-up edge appeared in all the cutting inserts after machining both alloys, which was removed for flank- and crater-wear measurements. Lower wear rates were observed for the Ti54M alloy, especially at high cutting speeds. In the same manner, cutting-force measurements showed lower specific cutting- and feed-force values for the Ti54M alloy. Adiabatic shear bands, a typical feature in the machining of titanium alloys, were observed in chips from both alloys under all cutting conditions. Finally, scanning electron microscopy observations were carried out to analyse the adhered material on the cutting edges of the worn tools where signs of diffusion and attrition were detected.