Abstract
The presented paper outlines the procedure and certain results of the experimental analysis of the strain and stress conditions in a billet during flat rolling. The photo-plasticity method of experimental stress analysis was used to solve the concerned problems. This application for evaluating stress and strain conditions allows to determine the directions as well as the differences of the main strains in the deformed material. The obtained data can then be used to deal with the static conditions of equilibrium by applying the shear stress difference method and the successive approximation method. What exists among the specified results is the comparison of experimental source materials obtained under both the conventional rolling process and multi-layer material rolling (the basis of the accumulative roll bonding process). The main attention was focused on the stress and strain conditions in both procedures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
