Abstract
We compare waveforms and orbital dynamics from the first long-term, fully nonlinear, numerical simulations of a generic black-hole binary configuration with post-Newtonian (PN) predictions. The binary has mass ratio q{approx}0.8 with arbitrarily oriented spins of magnitude S{sub 1}/m{sub 1}{sup 2}{approx}0.6 and S{sub 2}/m{sub 2}{sup 2}{approx}0.4 and orbits 9 times prior to merger. The numerical simulation starts with an initial separation of r{approx_equal}11M and orbital parameters determined by 2.5 PN and 3.5 PN evolutions of a quasi-circular binary starting from r=50M. The resulting binaries have very little eccentricity according to the 2.5 PN and 3.5 PN systems, but show eccentricities of e{approx}0.01-0.02 and e{approx}0.002-0.005 in the respective numerical simulations, thus demonstrating that 3.5 PN significantly reduces the eccentricity of the binary compared to 2.5 PN. We perform three numerical evolutions from r{approx_equal}11M with maximum resolutions of h=M/48, M/53.3, M/59.3, to verify numerical convergence. We observe a reasonably good agreement between the PN and numerical waveforms, with an overlap of nearly 99% for the first six cycles of the (l=2, m={+-}2) modes, 91% for the (l=2, m={+-}1) modes, and nearly 91% for the (l=3, m={+-}3) modes. The phase differences between numerical and post-Newtonian approximations appear to be independent of the (l,m) modesmore » considered and relatively small for the first 3-4 orbits. An advantage of the 3.5 PN model over the 2.5 PN one seems to be observed, which indicates that still higher PN order (perhaps even 4.0 PN) may yield significantly better waveforms. In addition, we identify features in the waveforms likely related to precession and precession-induced eccentricity.« less
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.