Abstract
Based on the research about the injection molding simulation technology such as 2.5-d model and 3D model, Numerical analysis on a same gas-assisted product was implemented using Moldflow software’s middle-face model and 3D model technology, and the physical experiment was also implemented. Through comparing the simulation results and experimental results, it shown that the time of the gas-assisted injection molding simulation based on 3D model is long, but the simulation results are more in line with experimental results than middle-face model. The numerical simulation using 3D model can truly and reliably predict the product’s molding process, and meet the demand to guide production.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.