Abstract
In this paper, two procedures to analyze planar multibody systems experiencing wear at a revolute joint are compared. In both procedures, the revolute joint of interest includes a clearance whose shape and size are dictated by wear. The procedures consist of coupled iterative analyses between a dynamic system analysis with nonideal joints and a wear prediction to determine the evolution of the joint clearance. In the first procedure, joint forces and contact pressures are estimated using the elastic foundation model with hysteresis damping via the dynamic analysis. In the second procedure, a contact force model with hysteresis damping is used to estimate the joint forces. In the latter case, however, the contact pressure is estimated using a finite element method (FEM). A comparison in performance of the two models is facilitated through the use of an experimental slider-crank mechanism in which wear is permitted to occur at one of the joints. It is observed that the two procedures provide similar estimates for the dynamic response and wear volumes but substantially different predictions on the wear profiles. Additionally, experimental results show that while predictions on the wear volume from both models are reasonably accurate, the FEM-based model produced more accurate predictions on the wear profile.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call