Abstract
This paper presents a comparison of thermal performance of helical screw tape inserts in laminar flow of Al 2O 3/water and CuO/water nanofluids through a straight circular duct with constant heat flux boundary condition. The helical screw tape inserts with twist ratios Y = 1.78, 2.44 and 3 were used in the experimental study using 0.1% volume concentration Al 2O 3/water and CuO/water nanofluids. Nanofluids with required volume concentration of 0.1% were prepared by dispersing specified amounts of Al 2O 3 and CuO nanoparticles in deionised water. The performance analysis of helical screw tape inserts in laminar flow of Al 2O 3/water and CuO/water nanofluids is done by evaluating thermal performance factor for constant pumping power condition. Thermal performance factor of helical screw tape inserts using CuO/water nanofluid is found to be higher when compared with the corresponding value using Al 2O 3/water. Therefore, the helical screw tape inserts show better thermal performance when used with CuO/water nanofluid than with Al 2O 3/water nanofluid.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.