Abstract
In this work, the effect of the nature of the salt anion (chloride and sulphate) in the Cu–Zn citrate bath was investigated, using cyclic voltammetry (CV) and chronoamperometry (CA). Experimental electrodeposition parameters (switching potential and imposed potential) were varied in order to examine their influence on the deposits. The coating microstructures were observed by scanning electron microscope (SEM-EDS), the coating phases were characterized by X-ray diffraction (XRD) analysis and the surface composition was assessed by XPS. Higher current efficiency was obtained in chloride baths compared to sulphate baths and best deposits were obtained at −1.4Vvs.(Ag/AgCl/KCl) compared to −1.2 and −1.5Vvs.(Ag/AgCl/KCl). Corrosion test results in 0.5 M NaCl solution show that Cu–Zn deposit produced from chloride bath exhibited the highest corrosion resistance.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
