Comparative study of chemical and physical foaming methods for injection-molded thermoplastic polyurethane

Abstract

Thermoplastic polyurethane is one of the most versatile thermoplastic materials being used in a myriad of industrial and commercial applications. Thermoplastic polyurethane foams are finding new applications in various industries including the furniture, automotive, sportswear, and packaging industries because of their easy processability and desirable customizable properties. In this study, three methods of manufacturing injection molded low density foams were investigated and compared: (1) using chemical blowing agents, (2) using microcellular injection molding with N2 as the blowing agent, and (3) using a combination of supercritical gas-laden pellets injection molding foaming technology and microcellular injection molding processes using co-blowing agents CO2 and N2. Thermal, rheological, microscopic imaging, and mechanical testing were carried out on the molded samples with increasing amounts of blowing agents. The results showed that the use of physical blowing agents yielded softer foams, while the use of CO2 and N2 as co-blowing agents helped to manufacture foams with lower bulk densities, better microstructures, and lower hysteresis loss ratios. Chemical blowing agent-foamed thermoplastic polyurethane showed an earlier onset of degradation. The average cell size decreased and the cell density increased with the use of co-blowing agents. A further increase in gas saturation levels showed a degradation of microstructure by cell coalescence.