Comparative evaluation of Z source / quasi Z-source direct and indirect matrix converters for PMG based WECS

Abstract

The present era sees the dominance of wind energy conversion systems as a leading technology in renewable energy. Various technologies have been devised to harness wind energy, with variable speed systems emerging as particularly advantageous. Consequently, these systems are designed to operate at specified speeds using power electronic interfaces, maximizing power extraction from the wind. The integration of Permanent Magnet Generators (PMGs), directly linked to the wind turbine lacking a gearbox, allows operation at minimum speeds. To stabilize the continuously fluctuating output voltage of the PMG, power electronic converters are extensively utilized in Wind Energy Conversion Systems (WECS), ensuring a consistent voltage and frequency output. The voltage gain of Traditional matrix converters (MCs) is limited to less than 0.866. In turn, the Z-source (ZS) and discontinuous QZSDMC, as well as ZS IMCs, topologies have achieved voltage gains exceeding 0.866. However, the former provides complicated commutation issues from DMC, while the latter incorporates a Z source network in the DC link, resulting in a non-all-silicon solution. A novel continuous QZSDMC and QZSIMC are suggested, wherein a qZS network incorporates the grid-side filtering function. This design eliminates the need for an additional input filter in the proposed system. Three newly introduced topologies of ZSDMC, QZSDMC and QZSIMC are thoroughly compared across various parameters including voltage gain, current and voltage ripples, inductor current and capacitor voltage stresses, filtering capabilities, input current, and output voltage Total Harmonic Distortion (THD), finally efficiency. The paper presents their control and modulation methods to achieve the desired performance levels. Experimental comparisons validate the theoretical analysis and demonstrate the potential of the proposed QZSDMC as a promising topology.