Abstract

The work presents estimated comparative assessment of emissions release in combustion products during work of high–power steam boilers with the use of traditional fuel – natural gas and alternative fuels – blast–furnace and coke–oven gases generated in the process of technological cycle at iron and steel and coke–chemical enterprises. Calculation algorithm is shown and formulas for assessment of carbon content in exhaust gases are defined, conclusions on ecological efficiency of gaseous fuels are given.
 The purpose of the work was to evaluate the emissions of harmful substances generated during the combustion of natural, blast furnace and coke oven gases, justification of the calculation of carbon content of a given chemical composition and determine the optimal environmental impact of analogues of natural gas.
 The comparative estimation of pollutant emissions into atmospheric air during combustion of natural, coke oven and blast furnace gases revealed:
 – high sulfur dioxide emissions from combustion of blast furnace and coke oven gases due to the presence of sulfur compounds in the composition of these gases;
 – relatively high emissions of nitrogen compounds for natural and coke oven gases and relatively low emissions for blast furnace gas;
 – сarbon emissions are high for all types of fuels which have been considered, most carbon dioxide gets into the air when burning natural gas, least – when burning blast furnace gas;
 – significantly higher methane emissions are observed during the combustion of natural and coke oven gases, respectively, smaller – for blast–furnace gas combustion;
 – coke oven and natural gases are characterized by low mercury emissions.
 Comparative assessment of the calculated values of hazardous substances emissions in the combustion products in the process of combustion of natural, coke–oven and blast–furnace gases shows that even at lower working heat of combustion values the coke–oven and blast–furnace gases can compete with natural gas.
 For the first time, a comparative characterization of the emissions of harmful substances in the combustion of natural, coke oven and blast furnace gases is presented, and it is shown that the gases used in coke and metallurgical industries, which are used as analogues of natural, are logical to use, but require the installation of treatment systems. The paper defines a formula for calculating the carbon content in natural gas from the Urengoy–Uzhhorod gas pipeline. The provided calculations and the introduction of simplified formulas serve as an example for the calculation of emission factors and emissions in assessing the level of safety of existing equipment and can be used in the development of permit documents of enterprises that carry out emissions of harmful substances to the environment.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call