Abstract
The aim of this study was to investigate the mechanical behavior of beech and fir finger joints under laboratory conditions. The samples were manufactured using a 9 mm finger joint with glued surfaces, in accordance with the EN 14 080 standard. Polyurethane adhesive of class D3, commonly used for the production of exterior wooden structures in Bosnia and Herzegovina, was applied to the samples. The specimens were subjected to destructive four-point bending tests according to the BAS EN 408 standard, and the achieved bending strength was statistically evaluated and compared to the results of unglued samples.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IOP Conference Series: Materials Science and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
