Commissioning of a Combined Hot-Streak and Swirl Profile Generator in a Transonic Turbine Test Facility

Abstract

AbstractBy enhancing the premixing of fuel and air prior to combustion, recently developed lean-burn combustor systems have led to reduced NOx and particulate emissions in gas turbines. Lean-burn combustor exit flows are typically characterized by nonuniformities in total temperature, or so-called hot-streaks, swirling velocity profiles, and high turbulence intensity. While these systems improve combustor performance, the exiting flow-field presents significant challenges to the aerothermal performance of the downstream turbine. This paper presents the commissioning of a new fully annular lean-burn combustor simulator for use in the Oxford Turbine Research Facility (OTRF), a transonic rotating facility capable of matching nondimensional engine conditions. The combustor simulator can deliver engine-representative turbine inlet conditions featuring swirl and hot-streaks either separately or simultaneously. To the best of our knowledge, this simulator is the first of its kind to be implemented in a rotating turbine test facility.The combustor simulator was experimentally commissioned in two stages. The first stage of commissioning experiments was conducted using a bespoke facility exhausting to atmospheric conditions (Hall and Povey, 2015, “Experimental Study of Non-Reacting Low NOx Combustor Simulator for Scaled Turbine Experiments,” ASME Paper No. GT2015-43530.) and included area surveys of the generated temperature and swirl profiles. The survey data confirmed that the simulator performed as designed, reproducing the key features of a lean-burn combustor. However, due to the hot and cold air mixing process occurring at lower Reynolds number in the facility, there was uncertainty concerning the degree to which the measured temperature profile represented that in OTRF. The second stage of commissioning experiments was conducted with the simulator installed in the OTRF. Measurements of the total temperature field at turbine inlet and of the high-pressure (HP) nozzle guide vane (NGV) loading distributions were obtained and compared to measurements with uniform inlet conditions. The experimental survey results were compared to unsteady numerical predictions of the simulator at both atmospheric and OTRF conditions. A high level of agreement was demonstrated, indicating that the Reynolds number effects associated with the change to OTRF conditions were small. Finally, data from the atmospheric test facility and the OTRF were combined with the numerical predictions to provide an inlet boundary condition for numerical simulation of the test turbine stage. The NGV loading measurements show good agreement with the numerical predictions, providing validation of the stage inlet boundary condition imposed. The successful commissioning of the simulator in the OTRF will enable future experimental studies of lean-burn combustor–turbine interaction.