Combined Explicit Finite and Discrete Element Methods for Rotor Bearing Dynamic Modeling

Abstract

This article presents a new approach in which the explicit finite element method (EFEM) and the discrete element method (DEM) are coupled to investigate dynamics of flexible rotor systems supported by deep-groove ball bearings. In this investigation, DEM is used to develop the bearing (dynamic motion) model in which all of the components of the bearing (i.e., inner and outer race, balls, and cage) have 6 degrees of freedom. The flexible shaft is modeled with a full 3D elastic formulation using the EFEM rather than the reduced form, which implements component mode synthesis. The EFEM and DEM were combined to investigate the dynamics of flexible shaft rotor systems supported by ball bearings. Rotor and inner races of the bearings are fully coupled such that both translation and rotation of the flexible rotor are transmitted to the bearings. At each time step, the translational motion and rotation/tilt angle of the rotor cross section at the location of an inner race are applied to the inner race of the bearing. The resulting reaction forces and moments calculated in the dynamic bearing model are in turn applied to the nodes of the shaft. The combined model is used to investigate the motions of the inner races and the resulting reaction forces and moments from the supporting bearings due to an applied load on the shaft. In the current coupled modeling approach, the deformation of the shaft affects the internal components of the bearing by altering the orientation of the inner race, which results in ball spin and slip.