Abstract

AbstractBackgroundThe present study was undertaken to evaluate the efficiency of combined technology involving ceramic microfiltration and biosorbent for the treatment of tannery effluent from different streams, viz. composite effluent, effluent from primary clarifier and secondary clarifier. The membranes were prepared from a cost-effective composition of alumina and clay.ResultsThe effluents had high organic loading of 12,895, 3,890 and 410 mg/L, respectively, in terms of chemical oxygen demand (COD). Apart from these, the effluents consisted of toxic heavy metals, turbidity, biochemical oxygen demand (BOD), etc. It was observed that COD reduction was about 96.5% for effluent 1, 96.6% for effluent 2 and 96.9% for effluent 3. Considerable reduction in suspended solids, total nitrogen, and total organic carbon was obtained. Turbidity for all three types of effluent was below 1 NTU. The average flux value for effluents 1, 2 and 3 was about 13, 19 and 24 L/m2/h (LMH), respectively. Response of the antioxidative defences ofEuphorbia hirtawas observed which resulted in considerable decrease in the activity of peroxidase, superoxide dismutase and catalase.ConclusionsThe treatment resulted in the reduction of toxicity thereby restoring normal activity when compared to control values. Changes in various biochemical parameters like protein, amino acid, carbohydrate, DNA, RNA and chlorophyll content were observed.

Highlights

  • The most polluting and oldest industry of the world is tanning industry

  • Use of a hybrid membrane bioreactor consisting of electro-coagulation, biological treatment and microfiltration was investigated for the removal of colour and chemical oxygen demand (COD) from tannery wastewater (Keerthi et al 2013)

  • The interaction occurs between the available sites on biosorbent and metals or organic matter

Read more

Summary

Introduction

The most polluting and oldest industry of the world is tanning industry. The demand for leather products is increasing with increasing population, thereby creating huge pollution load on the environment. Membrane bioreactors are being widely used for the treatment of tannery and other wastewater (Cassano et al 2001; Stephenson et al 2000; Suthanthararajan et al 2004.) Scholz et al (2005) has studied the use of a membrane bioreactor for the removal of organic pollutants and suspended solids from tannery effluent and followed it up with the use of reverse osmosis. Use of a hybrid membrane bioreactor consisting of electro-coagulation, biological treatment and microfiltration was investigated for the removal of colour and chemical oxygen demand (COD) from tannery wastewater (Keerthi et al 2013). The present study was undertaken to evaluate the efficiency of combined technology involving ceramic microfiltration and biosorbent for the treatment of tannery effluent from different streams, viz. The membranes were prepared from a cost-effective composition of alumina and clay

Objectives
Methods
Results
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call