Abstract
AbstractBecause of low cost, easily productivity and high thermal conductivity, aluminum (Al) moulds are preferred in the production of the polyurethane (PUR) parts. In this study, adhesion behavior and surface properties of coated materials between mould used in the production of automotive seat and PUR materials were investigated. Four different polymer types were coated on Al mould and they were characterized using contact angle, surface roughness, coating thickness, adhesion, cross-cut and SEM test methods. It was found that, PFA has the least value of surface roughness and ETFE has the highest one in the four different coatings produced. After holding period in isocyanate, decrease were measured on the angle values of all coatings. In the contact angle measurements before and after isocyanate tests, PFA exhibited the highest contact angle value.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
