CO2 Sorbents with Scaffold‐like CaAl Layered Double Hydroxides as Precursors for CO2 Capture at High Temperatures

Abstract

A highly stable high-temperature CO₂ sorbent consisting of scaffold-like Ca-rich oxides (Ca-Al-O) with rapid absorption kinetics and a high capacity is described. The Ca-rich oxides were prepared by annealing Ca-Al-NO₃ layered double hydroxide (LDH) precursors through a sol-gel process with Al(O(i)P)₃ and Ca(NO₃)₂ with Ca(2+)/Al(3+) ratios of 1:1, 2:1, 4:1, and 7:1. XRD indicated that only LDH powders were formed for Ca(2+)/Al(3+) ratios of 2:1. However, both LDH and Ca(OH)₂ phases were produced at higher ratios. Both TEM and SEM observations indicated that the Ca-Al-NO₃ LDHs displayed a scaffold-like porous structure morphology rather than platelet-like particles. Upon annealing at 600 °C, a highly stable porous network structure of the CaO-based Ca-Al-O mixed oxide (CAMO), composed of CaO and Ca₁₂Al₁₄O₃₃, was still present. The CAMO exhibited high specific surface areas (up to 191 m(2)g(-1)) and a pore size distribution of 3-6 nm, which allowed rapid diffusion of CO₂ into the interior of the material, inducing fast carbonation/calcination and enhancing the sintering-resistant nature over multiple carbonation/calcination cycles for CO₂ absorption at 700 °C. Thermogravimetric analysis results indicated that a CO₂ capture capacity of approximately 49 wt% could be obtained with rapid absorption from the porous 7:1 CAMO sorbents by carbonation at 700 °C for 5 min. Also, 94-98% of the initial CO₂ capture capability was retained after 50 cycles of multiple carbonation/calcination tests. Therefore, the CAMO framework is a good isolator for preventing the aggregation of CaO particles, and it is suitable for long-term cyclic operation in high-temperature environments.