Co-processing behavior of Gölbaşı lignite and poplar sawdust by factorial experimental design method

Abstract

In this work, the liquefaction of coal and biomass with direct liquefaction strategy was explored. The point of liquefaction is both to utilize a greater amount of the current coal and biomass assets all the more productively and to create an alternative liquid fuel to oil. Along these lines, the procedure parameters must be resolved to expand the liquefaction efficiency. In addition, it is proposed to do the liquefaction efficiency, particularly in the reactant conditions, to expand the measure of oil. Process parameters were controlled by utilizing Factorial Experimental Design technique in the liquefaction procedures. The solid/liquid ratio was changed as 1/2-1/4, the catalyst concentration was 2–6%, the temperature was 375–400 °C and the duration was 30–90 min. Starting nitrogen pressure was set at 30 bar, stirring speed was 400 rpm, coal/biomass proportion was settled at 1/1. Tetralin as a solvent and MoO3 as catalyst were utilized. Toward the finish of the liquefaction procedure, the total conversions were computed in view of the acquired non-reactive solid (char). As indicated by the outcomes obtained, the most total conversion (81.9%) was acquired at a solid/liquid proportion of 1/2, a catalyst concentration of 2%, a reaction time of 90 min and a reaction temperature of 400 °C. In light of total conversions and elective liquid fuel (oil) in the given conditions, the solid/liquid ratio should be taken as 1/2, the catalyst concentration is 2%, the reaction time is 30–90 min and the reaction temperature is 400 °C. The lowest reaction time found, in this study, is the innovative solution for reducing co-liquefaction cost preferred.